How Vertical Float Switch Works?

A vertical float switch is a mechanical device used to determine the level of a fluid in a tank and to trigger an event, such as a recharge or a discharge, when the fluid reaches one or more predetermined levels. The vertical float switch contains a magnet contained in the float through a tube, as well as a magnetic magnetic switch located in a fixed housing. The movement of the float due to changes in fluid level will cause the blade switch to close or open to a certain level. This proven technology is based on a relatively simple design that provides long-term reliability without having to operate a switch. Below we describe five common ways to use a vertical float switch.

Rainwater harvesting: rainwater harvesting is increasingly important, especially in drought-prone areas. Climate change affects the water supply during long periods of drought. Many states face a severe water shortage. That is why it is necessary to collect, store and treat rainwater. The tanks used to collect rainwater require vertical switches to indicate the level in the tank and to control the pumps and valves. Failure to comply with this precaution could result in costly water leakage and damage to property or equipment.

Wells

Many houses still use the well as the main source of water. The activation and deactivation of a well pump are normally controlled by vertical float switches. Normally two float switches are used, one on the top of the tank, to interrupt the electrical connection to the pump when the water level is too high. The other, located at the bottom of the tank, closes to create a connection to the pump when the water level drops too low. Together, these switches fill the tank and also prevent frequent activation of the well pump.

Dishwasher

Did you know that a device, such as a dishwasher, contains a vertical float switch? In most dishwashers, the float switch saves the fill timer. If the timer does not work properly, the switch turns the water off before the dishwasher overflows. When the water fills the dishwasher, the float rises. As soon as the float reaches a certain point, it activates the switch, which in turn sends a signal that prevents water from entering the dishwasher.

Boiler – Boilers are relatively simple machines that can be used for a variety of purposes. It is generally used as a heat source for buildings and homes. For most or all boiler configurations, vertical float switches are absolutely necessary for proper and safe operation. Applications for boiler circuit breakers in boilers include high water level alarms to prevent overflow, low level stops to avoid damage to the boiler system and pump control tools for water supply. of the boiler.

Aquarium

Vertical float switches can also be useful for an aquarium or aquarium. Evaporation causes problems in aquariums. When the water evaporates, it leaves the salt, increasing the salinity of the existing water. Saltwater fish need the chemical composition of water to remain stable and an excessive increase in salinity can kill them.

This can be corrected by filling the tank with fresh, clean water. The refueling system consists of a vertical float switch connected to a water pump, which is connected to a purified fresh water tank. When the evaporation is sufficient, the switch closes and the pump turns on. This causes water to enter the crankcase until the float switch opens when the pump stops. This allows reconstructing the aquarium, avoiding changes in salinity.

Therefore, the Quality Float Works vertical float switch is an original tool to indicate the water level, which serves as a measure of safety and comfort. It is an extremely versatile device used in many common applications!